IBM Books

Software User's Guide Version 3.4

Tables

  1. Processes, Their Purpose, and Commands to Access
  2. Network Architecture and the Supported Interfaces
  3. OPCON Commands
  4. Change Management Configuration Commands
  5. Service Recovery Commands
  6. Quick Config Capabilities
  7. CONFIG Command Summary
  8. Access Permission
  9. IBM 2212 Feature Numbers and Names
  10. Additional Functions Provided by the Set Prompt Level Command
  11. Default and Maximum Settings for Interfaces
  12. GWCON Command Summary
  13. Logging Levels
  14. Packet Completion Codes (Error Codes)
  15. ELS Configuration Command Summary
  16. ELS Net Filter Configuration Commands
  17. ELS Message Buffering Configuration Commands
  18. ELS Monitoring Command Summary
  19. ELS Net Filter Monitoring Commands
  20. ELS Message Buffering Monitoring Commands
  21. PERF Configuration Command Summary
  22. PERF Monitoring Command Summary
  23. Token-Ring Configuration Command Summary
  24. Token-Ring 4/16 Valid Packet Sizes
  25. Token-Ring Monitoring Command Summary
  26. LLC Configuration Command Summary
  27. LLC Monitoring Command Summary
  28. Configurations That May Result in Link Failure on the IBM 2212
  29. Configurations That May Result in Mismatched Duplex Modes During Operation
  30. Ethernet Configuration Command Summary
  31. Ethernet Monitoring Command Summary
  32. Set Command
  33. National Enable Parameters
  34. National Set Parameters
  35. Establishing Incoming X.25 Circuits for Closed User Groups
  36. X.25 Configuration Commands Summary
  37. Example VC Definitions
  38. X.25 Monitoring Command Summary
  39. XTP Configuration Commands Summary
  40. XTP Monitoring Commands Summary
  41. Protocol Address Mapping
  42. Data Generated by a Voice Port
  43. Frame Relay Management Options
  44. Frame Relay Configuration Commands Summary
  45. Frame Relay Management Options
  46. Transmit Delay Units and Range for the 2212 Serial Interface
  47. Frame Relay Monitoring Commands Summary
  48. LCP Packet Codes
  49. Point-to-Point Configuration Command Summary
  50. Point-to-Point Monitoring Command Summary
  51. MP Configuration Commands
  52. MP Monitoring Commands
  53. SDLC Relay Configuration Commands Summary
  54. Valid Values for Frame Size in Set Frame-Size Command
  55. SDLC Relay Monitoring Commands Summary
  56. SDLC Configuration Commands Summary
  57. Valid Values for Frame Size in Link Frame-Size Command
  58. SDLC Monitoring Commands Summary
  59. BSC Relay Configuration Commands Summary
  60. Valid Values for Frame Size in Set Frame-Size Command
  61. BSC Relay Monitoring Commands Summary
  62. V.25 bis Configuration Commands Summary
  63. V.25 bis Monitoring Command Summary
  64. V.34 Configuration Commands Summary
  65. V.34 Monitoring Command Summary
  66. ISDN Q.931 Cause Codes
  67. ISDN Configuration Command Summary
  68. ISDN Modem Configuration Command Summary
  69. ISDN Cause Codes Command Summary
  70. ISDN Monitoring Command Summary
  71. Digital Modem Monitoring Command Summary
  72. Dial Circuit Configuration Commands Summary
  73. Dial Circuit Configuration Commands Summary
  74. AT Command Set Summary
  75. The S-Register Summary
  76. V.34 Result Code Summary
  77. Result Code for 56K Mode
  78. Result Code Selection and Call Progress Monitoring

[ Top of Page | Previous Page | Next Page | Table of Contents | Index ]